The video describes to make wire hoop earrings. Take a steel metal of anything and take a eighteen gauge wire and wrap a few length of it around the taken piece of metal which is cylindrical in shape. Cut the wire at the desired part and remove from metal.The wire takes the shape of a standard spring. Again cut it into two or three pieces. Hold the wire again and straighten the edge and after that once again bend it down holding at the place where bent begins. Put some on it to design and then wrap it with player keeping in mind that a part should be excessed. Then wrap this existing part two or four times so that it takes a shape of an earing. Then put the ear wire through the raised part in between two wrapped part and it's ready.